DITEC CUBIC6 Specifications

Installation and maintenance manual for swing gates.(Original instructions)CUBIC6IP1812EN- rev. 2012-07-10DITEC S.p.A.Via Mons. Ban, 3 - 21042 Caronn

10IP1812EN • 2012-07-106.8 Installation with CUBIC6TIGFix the plate [A], then insert, x and lubricate the gears [B], [C] and [D]. Position the spher

11IP1812EN • 2012-07-107. ELECTRICAL CONNECTIONSBefore connecting the power supply, make sure the plate data correspond to that of the mains power su

12IP1812EN • 2012-07-10

13IP1812EN • 2012-07-10DETACH AND DELIVER TO THE CUSTOMER9.1 General safety precautionsThe following precautions are an integral and essential part of

14IP1812EN • 2012-07-10DETACH AND DELIVER TO THE CUSTOMERIn the event of failure or if there is no voltage:CUBIC6SBL: insert the lock release lever an

15IP1812EN • 2012-07-10

TMDITEC S.p.A. Via Mons. Ban, 3 21042 Caronno P.lla (VA) Italy Tel. +39 02 963911 Fax +39 02 9650314www.ditec.it [email protected] BELGI

2IP1812EN • 2012-07-10INDEXAll rights reservedAll data and specications have been drawn up and checked with the greatest care. The manufacturer canno

3IP1812EN • 2012-07-101. GENERAL SAFETY PRECAUTIONSThis installation manual is intended for professionally competent personnel only.Installation, ele

4IP1812EN • 2012-07-102. DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY(Directive 2006/42/EC, Annex II-B)The manufacturer DITEC S.p.A. wi

5IP1812EN • 2012-07-103. TECHNICAL DATACUBIC6 CUBI6H CUBIC6HVPower supply 230 V~ 50 Hz 24 V24 VAbsorption 1,5 A 12 A 12 ACouple 340 Nm 340 Nm 220 NmC

6IP1812EN • 2012-07-104. STANDARD INSTALLATIONRef. Code Description1 GOL4 Transmitter2 LAMPHLAMPFlashing light 24 V=Flashing light 230 V~3 XEL5GOL4MK

7IP1812EN • 2012-07-105. Examples applicationsmax 110° max 180° max 180° CUBIC6L - CUBIC6LGCUBIC6TCCUBIC6TIG

8IP1812EN • 2012-07-106. INSTALLATIONUnless otherwise specied, all measurements are expressed in millimetres (mm).6.1 Preliminary checks Check t

9IP1812EN • 2012-07-106.6 Installation with CUBIC6L-CUBIC6LGInsert lever [A] on the gearmotor and position the mechanical stop [B] and [C] and adjust