DITEC GLOBE Service Manual download pdf (Page 10)

IP1839EN • 2012-07-31

7. ASSEMBLING THE AUTOMATION

- Insert the guide [B] into the non-bevelled side of the coupling [C] until it reaches the stop.

- Insert the guide [D] into the bevelled side of the coupling [C] until it reaches the stop.

- Insert the guide [D] into the non-bevelled side of the coupling [E] until it reaches the stop.

- Lay out the belt or chain [A] and insert it into the carriage side of assembled guide [B]+[C]+[D]+[E].

- Mount the guide [B] on the drive unit and pass the belt or chain [A] over the pulley [H], blocking it with the

pin [I]. Attach the guide [B] to the drive unit using the screw [J].

- Place the guide [F] over the coupling [E].

- Insert the transmission [G] correctly into the guide [F], raising the guide to facilitate insertion.

- Insert the guide [F] into the coupling [E].

- the coupling [E] towards the transmission [G] until its reaches the guide stop [F].

B B

C C

1 2 3

370

1066 1066

205400 370205400 370

1066

205

B D F

C E

NOTE: the correct direction for inserting the guide in shown in the gure.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

DITEC GLOBE Service Manual Page 10