DITEC GLOBE Service Manual download pdf (Page 18)

IP1839EN • 2012-07-31

16. COMMANDS

Command Function Description

5 N.O. STEP-BY-STEP With DIP1=OFF, the closing of the contact activates opening

or closing operations in the following sequence: open-stop-

close-open.

Note: if automatic closing is enabled, the stop is not permanent

but lasts for a duration set by TC.

OPENING WITH

AUTOMATIC

CLOSING

With DIP1=ON and TC<MAX, the closing of the contact acti-

vates the opening operation.

OPENING WITHOUT

AUTOMATIC

CLOSING

With DIP1=ON and TC=MAX, the closing of the contact acti-

vates the opening operation.

Note: once the automation stops, the closing of the contact

performs the opposite operation to the one performed before

stop.

8 N.C. REVERSE

SAFETY CONTACT

The opening of the safety contact triggers a reversal of motion

(re-opening) during closing.

9 N.C. STOP The opening of the safety contact stops the current operation.

PRG

N.O. TRANSMITTERS

STORAGE AND

CANCELLATION

WARNING: the BIXMR2 storage module must be inserted.

Transmitter storage:

- press the PRG key (the SIG LED comes on),

- transmit the transmitter to be stored (the SIG LED ashes),

- wait 10 s to complete storage (the SIG LED goes out).

Transmitter cancellation:

- press the PRG key for 3 sec (the SIG LED ashes),

- press the PRG key for another 3 sec (the SIG LED ashes

quickly).

WARNING: make a jumper for all the N.C. contacts if not in use. The terminals with the same number

are equal.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

DITEC GLOBE Service Manual Page 18